Frame Relay Point To Multipoint Configuration Pdf Editor

Frame relay point to multipoint configuration pdf editor

Configurations

For routing traffic between devices will use EIGRP routing protocol, we have used series routers and one frame relay switch. Below is presented the topology.

Frame relay point to multipoint configuration pdf editor

Watch de video. As you have already seen we will configure R1 interface as multipoint but R2 and R3 as point-to-point. To get this working you have to do next configurations:.

Maybe this time chantal fernando pdf995

First we need to configure interfaces, subinterfaces, Frame Relay Encapsulation and Frame Relay mapping for our Routers. Very helpful.

Point to Multipoint Frame Relay

Your entire series is perfect. Please consider making more Youtube videos for all of your posts with continued good music …. I think is to R3 and is to R1 and so on.

Frame relay point to multipoint configuration pdf editor

The topology and the tutorial is very good and working fine. Can some one explain that why the ping from R1 to IP address ip address I tried to ping R1 serial interface IP.

I tried even to use Ping I hope that there is somebody who have a good explanation to that.

Frame relay point to multipoint configuration pdf editor

After searching every where in the internet…. Could you have configured R1 and R2 without subinterfaces?

Frame relay point to multipoint configuration pdf editor

I dont know if frame relay has to be all in the same subnet mask or not? R2 to R3 LAN ping output.

Frame relay point to multipoint configuration pdf editor

In the Topology there is small typing mistake i think. Oh, sorry for mistyping guys! Hello Dear, Thanks for the post, this helped me very much.

General english aptitude test questions answers pdf

Leave a comment.